- More info
- Powering related troubles are possible since USB Type-C is not PD-compliant
- Check quick review
- Enable video and 3D acceleration
- UART is accessible on a standard connector but with unusual speed: 1500000
- If you don’t have USB Type-C PSU, you can power the board via pins 4 (5V) and 6 (GND) of the 40-pin GPIO1 header
- Powering related troubles are possible since USB Type-C is not PD-compliant
- UART is accessible on a standard connector but with unusual speed: 1500000
- If you want to boot from your SD card you need to hold boot button while powering up/resetting
- You need to hold boot key and power/reset the device to force boot from SD card,
- Shutdown doesn’t work properly. It reboots the board.
- Devices, which memory number begins with SEC710 K4B4G16, need to do.:
- https://forum.armbian.com/topic/7274-nanopc-t3-boot-troubles/page/3/?tab=comments#comment-83688
- second serial console is enabled on a microUSB port
- occasional troubles with network driver
- https://forum.armbian.com/topic/7260-quick-review-of-nanopi-fire3/
- Shutdown doesn’t work properly. It reboots the board.
